GHS / HazCom term · Glossary
Hazard Statement (H-code)
Verified vs OSHA sources · 2026-10-05
A standardized phrase, with a fixed H-code, that describes the nature and degree of a chemical's hazard — for example H225, “Highly flammable liquid and vapor.” The wording is set by GHS and assigned to a specific hazard class and category, so the same hazard reads identically on every compliant label and SDS.
Also known as: H-statement, H-code
On this page
Hazard Statement (H-code) at a glance
- Wording is standardized and assigned by hazard class + category — not free text.
- Codes are grouped: H2xx physical, H3xx health, H4xx environmental.
- Codes are for reference; the full text (not just “H225”) must appear on the label.
- Combined statements use a “+”, e.g., H300 + H310.
In plain English
The fixed warning sentences on a chemical label — “Highly flammable,” “May cause cancer,” “Fatal if swallowed.” Each has a code (like H225) and standard wording, so the hazard says the same thing no matter the supplier or country.
What the rule says
“Hazard statement means a statement assigned to a hazard class and category that describes the nature of the hazard(s) of a chemical, including, where appropriate, the degree of hazard.”
In context
A classification or labeling concept from the UN Globally Harmonized System, adopted into US law through OSHA's Hazard Communication Standard (29 CFR 1910.1200) and its appendices.
Where this is written in OSHA's rules
- 29 CFR 1910.1200(c)Read on eCFR / OSHA.gov
Example
Acetone is a Flammable Liquid Category 2, so it carries the hazard statement H225, “Highly flammable liquid and vapor.” It's also classified for eye irritation (H319, “Causes serious eye irritation”) — each H-statement comes from a specific class and category.
Why it matters
Hazard statements are the plain-language warnings workers actually read. Putting the wrong H-statement, only the code, or dropping one for a hazard the chemical has, misinforms users and is a HazCom labeling violation under 1910.1200(f).
Hazard statement vs. precautionary statement
A hazard statement (H-code) describes the danger — “Highly flammable liquid and vapor.” A precautionary statement (P-code) tells you what to do about it — “Keep away from heat, sparks, open flames.” Both appear on a GHS label, but they answer different questions.
Hazard statement (H-code) numbering
| Series | Hazard type | Example |
|---|---|---|
| H2xx | Physical hazards | H225 — Highly flammable liquid and vapor |
| H3xx | Health hazards | H350 — May cause cancer |
| H4xx | Environmental hazards | H400 — Very toxic to aquatic life |
Hazard Statement (H-code): frequently asked questions
- What is the difference between a hazard statement and a precautionary statement?
- A hazard statement (H-code) describes the hazard itself (e.g., “Highly flammable liquid and vapor”). A precautionary statement (P-code) describes the recommended action to prevent or respond to it (e.g., “Keep away from heat”). Both appear on the label.
- Do I have to print the H-code or the full text?
- The full hazard statement text must appear on the label. The code (e.g., H225) is a reference identifier; it does not replace the wording, though both are commonly shown.
- What do the H-code numbers mean?
- The first digit groups the hazard: H2xx for physical hazards, H3xx for health hazards, and H4xx for environmental hazards. The remaining digits identify the specific statement.
Related terms
Free tools for this
Governing OSHA standards
More GHS terms
A GHS health-hazard class for the harmful effects that follow a single dose, several doses within 24 hours, or a 4-hour inhalation exposure. Chemicals are sorted into categories by route (oral, dermal, inhalation) using LD50/LC50 cut-offs — Category 1 is the most toxic. OSHA's HazCom standard uses Categories 1–4.
Aspiration HazardA GHS health-hazard class for chemicals that can be fatal if swallowed and then enter the airways — directly or by vomiting — causing chemical pneumonia or lung injury. Thin, low-viscosity hydrocarbons (gasoline, kerosene, lamp oil) are the classic example. It is Category 1, with the health-hazard pictogram (GHS08) and signal word “Danger.”
CarcinogenicityA GHS health-hazard class for chemicals that cause cancer or increase its incidence. GHS (and OSHA's HazCom standard) sorts carcinogens into Category 1A (known human carcinogen), 1B (presumed, from animal evidence), and Category 2 (suspected). Carcinogens carry the health-hazard pictogram (GHS08) and a hazard statement such as H350 (“May cause cancer”).
Chemicals Under PressureA physical-hazard class added by OSHA's 2024 HCS update (aligning with GHS Revision 7) for liquids or solids pressurized with a gas, held in pressure receptacles other than aerosol dispensers and not classified as gases under pressure. It is categorized by the flammability of its contents and always carries the gas-cylinder pictogram (GHS04) for the pressure hazard.
ClassificationThe process of evaluating the available scientific evidence for a chemical against the GHS criteria to decide whether it is hazardous and, if so, the hazard class and category of each effect. Classification is the first step in HazCom — its result determines every label element (pictogram, signal word, hazard and precautionary statements) and SDS content.
Corrosive to MetalsA GHS physical-hazard class for chemicals that, by chemical action, will materially damage or even destroy metals. It is a single category (Category 1), determined by corrosion-rate testing on steel and aluminum, and uses the corrosion pictogram (GHS05) with the hazard statement H290. It is a separate hazard from skin corrosion, even though both use GHS05.
Desensitized ExplosivesA physical-hazard class added by OSHA's 2024 HCS update (GHS Revision 7) for solid or liquid explosives that have been phlegmatized — wetted or diluted — to suppress their explosive properties for safe transport and storage. It has four categories based on the corrected burning rate, and uses the flame pictogram (GHS02), not the exploding-bomb.
Globally Harmonized System (GHS)An internationally agreed framework created by the United Nations (first adopted in 2003) that standardizes how chemical hazards are classified and communicated — using common hazard classes, pictograms, signal words (Danger / Warning), and coded hazard (H) and precautionary (P) statements on labels and safety data sheets. The US adopted GHS into law through OSHA's 2012 Hazard Communication Standard update.
Sources & verification
- 29 CFR 1910.1200(c) (eCFR / OSHA.gov)
- OSHA — Hazard Communication (labels)
- UNECE GHS — Annex 3: Codification of statements
Reviewed by HazComFast against eCFR, OSHA.gov, NIOSH, and the Federal Register. Last reviewed 2026-10-05. This glossary is general information, not legal advice; OSHA State-Plan states (e.g. California, Michigan) may adopt stricter requirements.
Put Hazard Statement (H-code) into practice
Don't just read the definition — apply it. Use the free GHS Label Generator to put real numbers behind Hazard Statement (H-code) for your jobsite.
Get the Binder in Order Before the Inspector Arrives. Are You Ready?
OSHA does not give advance notice of inspections (29 CFR 1903.6). Get the binder in order before the opening conference, not during it.
Serious Violation
$16,550
per violation (max)
HazComFast Pro
$199/mo
10 jobsites, unlimited chemicals, unlimited workers
New sign-ups are paused. The free tools below need no account, and customers can log in as usual.
Your account keeps working as usual. Cancel anytime.