GHS / HazCom term · Glossary
Chemicals Under Pressure
Verified vs OSHA sources · 2026-10-05
A physical-hazard class added by OSHA's 2024 HCS update (aligning with GHS Revision 7) for liquids or solids pressurized with a gas, held in pressure receptacles other than aerosol dispensers and not classified as gases under pressure. It is categorized by the flammability of its contents and always carries the gas-cylinder pictogram (GHS04) for the pressure hazard.
Also known as: CUP
On this page
Chemicals Under Pressure at a glance
- New in OSHA's 2024 HCS (GHS Revision 7) — did not exist in the 2012 standard.
- Distinct from gases under pressure and from aerosols.
- Categorized by the flammability of the contents (Category 1 flammable → Category 3 non-flammable).
- Always uses the gas-cylinder pictogram (GHS04); flammable contents add the flame (GHS02).
In plain English
A newer GHS hazard bucket for products that are liquids or solids held under gas pressure — but that aren't simple compressed gases or spray aerosols. The pressure itself is a hazard (it can burst if heated), and if the contents are flammable that adds a fire risk.
What the source says, in summary
Chemicals under pressure are liquids or solids (e.g., pastes or powders), pressurized with a gas at a pressure of 200 kPa (gauge) or more at 20 °C in pressure receptacles other than aerosol dispensers and which are not classified as gases under pressure.
In context
A classification or labeling concept from the UN Globally Harmonized System, adopted into US law through OSHA's Hazard Communication Standard (29 CFR 1910.1200) and its appendices.
Where this is written in OSHA's rules
- 29 CFR 1910.1200 App B.3Read on eCFR / OSHA.gov
Example
A pressurized adhesive or sealant dispensed from a gas-charged cylinder (not a spray aerosol can) can fall into the chemicals-under-pressure class. Its label carries the gas-cylinder pictogram (GHS04) for the pressure hazard, plus the flame (GHS02) if the contents are flammable.
Why it matters
Because this class is new in the 2024 HCS, many existing products must be reclassified and relabeled by the phased compliance dates. Treating a chemical under pressure as a plain aerosol or gas can put the wrong pictograms on the label — a HazCom gap during and after the transition.
Chemicals under pressure vs. gases under pressure vs. aerosols
“Gases under pressure” is a gas stored under pressure (compressed, liquefied, refrigerated, or dissolved). An “aerosol” sprays its contents when you press the actuator. “Chemicals under pressure” is the newer in-between class — a liquid or solid held under gas pressure that isn't either of the other two.
Chemicals under pressure vs. related classes
| Class | What it is |
|---|---|
| Chemicals under pressure | Liquid/solid pressurized with a gas (new in 2024 HCS) |
| Gases under pressure | A gas stored under pressure (compressed, liquefied, refrigerated, dissolved) |
| Aerosols | Pressurized dispensers that spray contents on actuation |
Chemicals Under Pressure: frequently asked questions
- What is the difference between chemicals under pressure and gases under pressure?
- Gases under pressure is a gas stored under pressure (e.g., compressed, liquefied). Chemicals under pressure is a liquid or solid pressurized with a gas that isn't a gas under pressure or an aerosol — a separate class added in the 2024 HCS.
- When did 'chemicals under pressure' become a hazard class?
- In OSHA's 2024 update to the Hazard Communication Standard, which aligned the US with GHS Revision 7. It did not exist under the 2012 HCS, so affected products are being reclassified during the phased compliance period.
- What pictogram does it use?
- Always the gas-cylinder pictogram (GHS04) for the pressure hazard. If the contents are flammable, the flame pictogram (GHS02) is added.
Related terms
Free tools for this
Governing OSHA standards
More GHS terms
A GHS health-hazard class for the harmful effects that follow a single dose, several doses within 24 hours, or a 4-hour inhalation exposure. Chemicals are sorted into categories by route (oral, dermal, inhalation) using LD50/LC50 cut-offs — Category 1 is the most toxic. OSHA's HazCom standard uses Categories 1–4.
Aspiration HazardA GHS health-hazard class for chemicals that can be fatal if swallowed and then enter the airways — directly or by vomiting — causing chemical pneumonia or lung injury. Thin, low-viscosity hydrocarbons (gasoline, kerosene, lamp oil) are the classic example. It is Category 1, with the health-hazard pictogram (GHS08) and signal word “Danger.”
CarcinogenicityA GHS health-hazard class for chemicals that cause cancer or increase its incidence. GHS (and OSHA's HazCom standard) sorts carcinogens into Category 1A (known human carcinogen), 1B (presumed, from animal evidence), and Category 2 (suspected). Carcinogens carry the health-hazard pictogram (GHS08) and a hazard statement such as H350 (“May cause cancer”).
ClassificationThe process of evaluating the available scientific evidence for a chemical against the GHS criteria to decide whether it is hazardous and, if so, the hazard class and category of each effect. Classification is the first step in HazCom — its result determines every label element (pictogram, signal word, hazard and precautionary statements) and SDS content.
Corrosive to MetalsA GHS physical-hazard class for chemicals that, by chemical action, will materially damage or even destroy metals. It is a single category (Category 1), determined by corrosion-rate testing on steel and aluminum, and uses the corrosion pictogram (GHS05) with the hazard statement H290. It is a separate hazard from skin corrosion, even though both use GHS05.
Desensitized ExplosivesA physical-hazard class added by OSHA's 2024 HCS update (GHS Revision 7) for solid or liquid explosives that have been phlegmatized — wetted or diluted — to suppress their explosive properties for safe transport and storage. It has four categories based on the corrected burning rate, and uses the flame pictogram (GHS02), not the exploding-bomb.
Globally Harmonized System (GHS)An internationally agreed framework created by the United Nations (first adopted in 2003) that standardizes how chemical hazards are classified and communicated — using common hazard classes, pictograms, signal words (Danger / Warning), and coded hazard (H) and precautionary (P) statements on labels and safety data sheets. The US adopted GHS into law through OSHA's 2012 Hazard Communication Standard update.
GHS Revision 7The 7th revision of the UN Globally Harmonized System, which OSHA adopted in its 2024 update to the Hazard Communication Standard (with selected elements of Revision 8). It adds new hazard classes — desensitized explosives and chemicals under pressure — folds pyrophoric and chemically unstable gases into flammable gases, and updates label and SDS provisions. The final rule was effective July 19, 2024, with phased compliance dates.
Sources & verification
- 29 CFR 1910.1200 App B.3 (eCFR / OSHA.gov)
- OSHA — Hazard Communication Standard 2024 Final Rule
- OSHA — Appendix B to §1910.1200: Physical Criteria (Mandatory)
Reviewed by HazComFast against eCFR, OSHA.gov, NIOSH, and the Federal Register. Last reviewed 2026-10-05. This glossary is general information, not legal advice; OSHA State-Plan states (e.g. California, Michigan) may adopt stricter requirements.
Put Chemicals Under Pressure into practice
Don't just read the definition — apply it. Use the free GHS Rev 7 Transition Wizard to put real numbers behind Chemicals Under Pressure for your jobsite.
Get the Binder in Order Before the Inspector Arrives. Are You Ready?
OSHA does not give advance notice of inspections (29 CFR 1903.6). Get the binder in order before the opening conference, not during it.
Serious Violation
$16,550
per violation (max)
HazComFast Pro
$199/mo
10 jobsites, unlimited chemicals, unlimited workers
New sign-ups are paused. The free tools below need no account, and customers can log in as usual.
Your account keeps working as usual. Cancel anytime.