Fall Protection

The part of Title 29 of the Code of Federal Regulations that contains OSHA's General Industry standards — the default rulebook for most American workplaces (manufacturing, warehousing, healthcare, etc.) that aren't covered by the construction, maritime, or agriculture standards. It includes core rules like Hazard Communication (1910.1200) and the permissible exposure limits (1910.1000). Several 1910 standards are cross-referenced into construction via Part 1926.

The part of Title 29 of the Code of Federal Regulations that contains OSHA's Construction standards — the “Safety and Health Regulations for Construction.” It governs construction, alteration, and repair work, with construction-specific rules for fall protection (Subpart M), scaffolds (Subpart L), excavations (Subpart P), electrical (Subpart K), and more. Where a task isn't addressed in 1926, some general-industry (1910) standards apply by reference.

The secure attachment point a personal fall arrest system (PFAS) ties off to — the “A” in the ABC of fall arrest. Under 29 CFR 1926.502(d)(15), a non-engineered anchorage must support at least 5,000 pounds per attached worker; alternatively, it can be an engineered anchorage designed and supervised by a qualified person with a safety factor of at least two.

Measuring the air in a confined space (or other hazardous atmosphere) with a calibrated direct-reading instrument before and during entry. OSHA requires testing in a set order — oxygen first, then flammable gases and vapors, then potential toxic contaminants — and defines the acceptable ranges: oxygen 19.5%–23.5%, flammables below 10% of the LEL, toxics below their exposure limits.

An excavation cave-in protective system that cuts the sides into a series of horizontal steps (benches), usually with vertical or near-vertical faces between levels. It's one of OSHA's accepted protective systems under Subpart P — but it is NOT permitted in Type C (the least stable) soil.

The competent person OSHA's excavation standard (Subpart P) requires on every trenching job — someone trained in soil classification and protective systems, who can identify cave-in and other hazards AND has authority to remove workers and correct problems. They must inspect the excavation daily before work starts, throughout the shift, and after any rain or event that could increase the hazard.

A space that is large enough for a worker to bodily enter, has limited or restricted means of entry or exit, and is not designed for continuous occupancy. If it also contains — or could contain — a serious hazard (a hazardous atmosphere, engulfment material, an entrapping configuration, or any other recognized serious hazard), it becomes a permit-required confined space (PRCS).

Under OSHA's Multi-Employer Citation Policy (CPL 02-00-124), the controlling employer is an employer with general supervisory authority over a worksite — including the power to correct safety and health violations itself or to require others to correct them. This is typically the general contractor or construction manager. A controlling employer can be cited for a hazard at the site even if none of its own employees are exposed, because it has a duty to exercise reasonable care to prevent and detect violations by the other employers on site.