Skip to content

Urgent: Nov 20, 2026 — HCS 2024 Deadline. Get ready →

Safety data sheet

Klean-Strip Odorless Mineral Spirits SDS

W. M. Barr's sheet for Klean-Strip Odorless Mineral Spirits lists four hazard classes, among them flammable liquids, Category 3, so it is a hazardous chemical as 29 CFR 1910.1200(c) defines it. The HazCom program, label, sheet and training paragraphs follow ((e)(1), (f)(6), (g)(8) and (h)(1)), unless a scope paragraph of (b) takes the product out.

Product as the sheet names it
Klean Strip Odorless Mineral Spirits
Maker
W. M. Barr
Product code
GKSP94006P, QKSP94005, QKSP945, GKSP94006, GKSP94214
Revision date as read on Oct 21, 2026
Nov 5, 2021 (the sheet calls it "Revision")

Klean Strip Odorless Mineral Spirits in the product codes listed (the California version has its own sheet).

What this SDS tells an employer

Read in the maker's sheet on October 21, 2026: Product code GKSP94006P, QKSP94005, QKSP945, GKSP94006, GKSP94214, Revision Nov 5, 2021, 7 pages. The maker's version is the one that counts.

Klean Strip Odorless Mineral Spirits: facts read in the safety data sheet, by section
Section 2, hazards

Section 2 lists flammable liquids Category 3, skin corrosion/irritation Category 2, specific target organ toxicity single exposure Category 3, and aspiration toxicity Category 1.

Signal word: Danger. Pictograms: Flame (GHS02), Exclamation Mark (GHS07), Health Hazard (GHS08).

Hazard statements: H226, H304, H315, H336. Their text, in English and Spanish, is on the label below.

Section 3, ingredients
  • Hydrotreated light distillate, petroleum or mineral spirits (CAS 64742-47-8), at 100 %.
Section 4, first aid
  • Inhaled: if breathing is difficult, move to air free of vapors. Give oxygen or artificial respiration until medical help arrives.
  • Skin: wash with soap and large quantities of water for at least 15 minutes. Seek medical attention if irritation persists.
  • Eyes: flush with water at once, remove any contact lens and keep flushing for at least 15 minutes. Get medical attention.
  • Swallowed: do not induce vomiting. Call a poison control center, hospital emergency room or physician at once.
Section 5, fire fighting
  • Use carbon dioxide, dry chemical powder or foam.
  • NFPA class II, autoignition point 456.80 °F, flammable limits 0.6 % and 5.5 %.
Section 7, handling and storage
  • Keep the container tightly closed when not in use, in a cool, dry place.
  • Do not store near flames or at high temperatures.
  • Follow all label warnings even after the container is empty, because the empty container retains residue.
Section 8, exposure limits

The sheet lists no OSHA permissible exposure limit for this product. Only an ACGIH TLV of 200 mg/m3 is listed for the distillate; the sheet lists no OSHA PEL.

Section 8, protection

Respiratory protection: For occasional use where engineered air control is not feasible, use a properly fitted NIOSH approved respirator for organic solvent vapors.

  • Safety glasses, chemical goggles or face shields.
  • Protective gloves and other protective clothing as the sheet names.

The sheet does not name eyewash equipment.

Section 9, flash point> 105.80 °F, Tag closed cup
Section 9, other properties
  • Colorless to light yellow liquid with a solvent odor.
  • Melting point -72.40 °F. Boiling range 318.20 to 354.20 °F. Vapor pressure 3 mm Hg at 25.0 °C. Vapor density 4.5 (air = 1). Evaporation rate under 1 (butyl acetate = 1).
  • Specific gravity 0.78. Very slightly soluble in cold water (1.5 g/L). VOC 780 g/L.
  • Conductivity under 5 picosiemens per meter when unadditized.
Section 10, what to avoid
  • Avoid all sources of ignition. Do not pressurize, cut, weld, braze, solder, drill, grind or expose containers to heat, and do not let vapor collect in low or confined areas.
  • Incompatible with strong oxidizing agents. Thermal decomposition may produce carbon monoxide and carbon dioxide.
Section 14, transportUN1263, Paint related material, hazard class 3, packing group III. The shipper may apply the exceptions the sheet names, such as limited quantity or consumer commodity, under 49 CFR.

What this product triggers under OSHA

The sheet says the product is regulated by the United States Consumer Product Safety Commission. The standard does not apply to a consumer product the employer shows is used as its maker intended, at no more than consumer exposure. (29 CFR 1910.1200(b)(6)(ix), (b)(5)(v))

Section 2 lists a Category 3 flammable liquid and Section 9 gives > 105.80 °F, Tag closed cup, which is not below 100 °F, the line the general industry paragraph on dispensing draws; the construction paragraph names Category 1, 2 and 3. (29 CFR 1910.106(e)(6)(ii); 1926.152(e)(2))

Section 8 mentions a respirator: the employer provides one when necessary to protect health and keeps a respiratory protection program. (29 CFR 1910.134(a)(2); 1926.103)

A classified product brings a written program with its chemical list, training, an accessible sheet and workplace labels. (29 CFR 1910.1200(c), (e)(1), (f)(6), (g)(8), (h)(1); 1926.59)

Container label from this SDS

For a container of Klean-Strip Odorless Mineral Spirits you fill at work (29 CFR 1910.1200(f)(6)).

Klean Strip Odorless Mineral Spirits

Danger / Peligro

  • Flame pictogram (GHS02)Flame / Llama
  • Exclamation Mark pictogram (GHS07)Exclamation Mark / Signo de exclamación
  • Health Hazard pictogram (GHS08)Health Hazard / Peligro para la salud
Hazard statements in English and Spanish
CodeEnglish (as the sheet prints it)Español (official European text)
H226Flammable liquid and vapor.Líquidos y vapores inflamables.
H304May be fatal if swallowed and enters airways.Puede ser mortal en caso de ingestión y penetración en las vías respiratorias.
H315Causes skin irritation.Provoca irritación cutánea.
H336May cause drowsiness or dizziness.Puede provocar somnolencia o vértigo.

The label carries 22 precautionary statements (P210, P233, P241, P242, P243, P261, P264, P271, P280, P235, P301, P310, P302, P352, P303, P361, P353, P304, P340, P312, P321, P331, P332, P313, P362, P403, P405, P501), and the PDF prints their full text. 18 of its 26 lines have official Spanish; a line marked English only has none that says the same.

Next

Trades: Painting contractors, Building maintenance. Similar products: Klean-Strip Acetone, Klean-Strip Paint Thinner. Another product: SDS Lookup.

Finding the Klean-Strip Odorless Mineral Spirits sheet is the easy part

Keeping every sheet read, current and ready for an inspector is the work that never ends. HazComFast does it with your crew: the AI extracts each sheet, and every reading leaves a proof.

Extraction: the AI reads every sheet

Scanned, long or in Spanish, it reads

Drop in the Klean-Strip Odorless Mineral Spirits sheet, scanned or not, in English or Spanish. HazComFast reads every page, with progress shown page by page, so a 32-page sheet gets read to the last page.

Every section a foreman needs

Composition, spill response, storage, physical properties, stability and toxicology land on the product page with their source, so the sections a foreman actually needs aren't buried in a PDF.

The AI proposes, a person signs off

Each hazard shows where it came from: extracted from the sheet, or confirmed by a named person on a date. Confidence is measured against the text of the sheet, and below a floor every field is checked by hand before it saves.

A pictogram is never guessed

A pictogram only goes on your label if it's actually on the sheet or follows from its H-codes. H225 on the sheet means GHS02 and DANGER on the label, derived from OSHA's Appendix C.

Checked against 200 real sheets

Every change to the AI is checked against a reference set of 200 real SDSs before it ships. A field it isn't sure about is highlighted for you to check, and the inventory flags products whose extraction hasn't been validated yet.

Proof of reading, without the chasing

Nobody has to remember to ask

Add a hazardous product to a site and every worker there gets one notice with a 7-day due date. A reminder follows at day 3 and an escalation at day 7.

“I read it” can't be a reflex tap

The confirm button stays grey until the worker has scrolled through first aid or to the last page of the PDF and has spent 15 seconds there. The record keeps how long and how far.

A proof of reading the worker keeps

The worker ticks an attestation, and the record keeps which SDS version they read, the server time and the device. They can download their own PDF of it.

A new sheet means a new reading

When a manufacturer updates a sheet and the hazards change, everyone who confirmed the old one is asked to read the new one. Each confirmation keeps which version they read, for which jobsite.

Who read what, in one console

See who hasn't read what, nudge everyone overdue in one click, and export last month's confirmations for one jobsite, each with the SDS version they read.

The reading joins the training file

Each confirmed reading also lands in the worker's training file as a HazCom reading record, so your training records and your SDS records tell the same story.

From the sheet to the label

A label that can't go out empty

A label with five pictograms keeps all five, because the format switches. A label with no hazard information won't print. When the sheet changes, you get a relabeling task with its six-month deadline.

English and Spanish, side by side

Hazard and precautionary statements show in English and Spanish on every product page. A Spanish sheet that says PELIGRO is recorded as DANGER, and the original file stays attached as you received it.

Every print on record

Every print run is logged with exactly what went on the labels. When a hazard changes, the relabel task can only be closed by a print made after the change.

In the field, on the phone

Scan the drum

Scan the QR code on a drum and the page shows the maker and the CAS number under the title, so you know you hold the right one. A drum taken out of inventory still opens its SDS, marked as removed.

Search inside the sheet

Type “eye contact” and you land on first aid. Pinch to zoom on the small print.

Still there with no signal

Offline, the worker opens the sheet itself, with first aid and what to do in a spill. “Available offline” only shows when the PDF is on the phone.

When the inspector asks

The binder, in one click

One click gives you the jobsite's SDS binder, with Klean-Strip Odorless Mineral Spirits in it, as a ZIP with a CSV index, and a dated CSV or PDF of who confirmed reading what. That is what you hand an inspector or a GC.

No expired-sheet myth

HazComFast never tells you a sheet has expired, because OSHA doesn't set an expiration date. You choose your own review interval, and the app labels it as your internal policy.

The chemical list behind it

Bring your spreadsheet

Imported products get the same pictograms as ones entered by hand, and importing the same file twice doesn't duplicate anything.

Each product, at every site

Each product page shows every site it's stored at with quantities, and warns you if something incompatible is stored at the same site.

A program that stays true

The chemical list in your HazCom program is built from each jobsite's inventory. Remove a product and the program tells you the list is out of date, with a button to rebuild it.

Start with the free SDS Binder Kit. It works with nothing but a printer.

Free to use as well: the chemical inventory template and the SDS QR code generator. The software side: the chemical inventory in HazComFast.

Questions about Klean-Strip Odorless Mineral Spirits

Where do I get the SDS for Klean-Strip Odorless Mineral Spirits?

From W. M. Barr. The button at the top of this page opens its own copy (many product codes, Revision Nov 5, 2021). It covers Klean Strip Odorless Mineral Spirits in the product codes listed (the California version has its own sheet).

Is Klean-Strip Odorless Mineral Spirits a hazardous chemical under OSHA?

Yes: Section 2 lists four hazard classes, among them flammable liquids, Category 3 (29 CFR 1910.1200(c)). Its consumer wording matters (1910.1200(b)(6)(ix)).

Sources and notes