Goo Gone's sheet for Goo Gone Goo & Adhesive Remover lists aspiration toxicity, Category 1; skin sensitization, Category 1, so it is a hazardous chemical as 29 CFR 1910.1200(c) defines it. The HazCom program, label, sheet and training paragraphs follow ((e)(1), (f)(6), (g)(8) and (h)(1)), unless a scope paragraph of (b) takes the product out.
Read in the maker's sheet on October 21, 2026: Product no. 2030A, 2034D, 2051D, 2087, 2089, 2089A, 2092A, 2095CLIP, 2129, 2139B, 2166D, 2221D, 2223, SDS date Sep 19, 2024, 11 pages. The maker's version is the one that counts.
Goo Gone Goo & Adhesive Remover: facts read in the safety data sheet, by section
Section 2, hazards
Section 2 calls the material hazardous under the OSHA Hazard Communication Standard and lists aspiration toxicity, Category 1, and skin sensitization, Category 1.
Signal word: Danger. Pictograms: Exclamation Mark (GHS07), Health Hazard (GHS08).
Hazard statements: H304, H317. Their text, in English and Spanish, is on the label below.
Section 3, ingredients
Distillates (petroleum), hydrotreated light (CAS 64742-47-8) at 80 to 95 %, d-limonene (CAS 5989-27-5) at 3 to 5 %, and orange oil (CAS 8028-48-6) at 1 to 3 %.
The sheet withholds the exact concentration where an ingredient is given as a range.
Section 4, first aid
Inhaled: if breathing is difficult or the airways are irritated, bring the person into fresh air and stay with them.
Skin: remove contaminated clothing and shoes at once and wash with water and soap, never with solvents or thinners. Get medical advice if irritation occurs.
Eyes: flush with water or saline (20 to 30 °C) for at least 5 minutes, remove contact lenses, seek medical help and keep flushing during transport.
Swallowed: call a poison center or doctor at once and do not induce vomiting. Keep the head facing down if vomiting occurs, and keep the person under medical attention for at least 48 hours because chemical pneumonia can appear after several hours.
Section 5, fire fighting
Use alcohol-resistant foam, carbon dioxide, powder or water mist. Do not use water jets, which can spread the fire.
Fire produces dense smoke. Cool closed containers exposed to fire with water, and keep extinguishing water out of sewers and surface water.
Firefighters wear self-contained breathing apparatus and protective clothing.
Section 7, handling and storage
Reseal opened containers carefully and keep them upright to prevent leakage.
Keep only in the original packaging, in a dry, cool, well-ventilated place.
Incompatible with strong acids, strong bases, and strong oxidizing and reducing agents.
Section 8, exposure limits
The sheet lists no OSHA permissible exposure limit for this product. The sheet lists no substance with a permissible exposure limit in Table Z-1 of 29 CFR 1910.1000.
Section 8, protection
Respiratory protection: No special respiratory equipment when used as intended.
No special eye or skin protection when used as intended.
Wash exposed skin thoroughly after use, with attention to hands, forearms and face.
The sheet does not name eyewash equipment.
Section 9, flash point
> 200 °F
Section 9, other properties
Yellow liquid with a citrus odor. Relative density 0.7936 to 0.8136.
Section 10, what to avoid
Do not expose to any form of heat, such as solar radiation, which may lead to excess pressure.
Incompatible with strong acids, strong bases, and strong oxidizing and reducing agents.
Section 14, transport
Not dangerous goods according to DOT, IATA and IMDG.
What this product triggers under OSHA
The standard does not apply to a consumer product the employer shows is used as its maker intended, at no more than consumer exposure. (29 CFR 1910.1200(b)(6)(ix), (b)(5)(v))
A classified product brings a written program with its chemical list, training, an accessible sheet and workplace labels. (29 CFR 1910.1200(c), (e)(1), (f)(6), (g)(8), (h)(1); 1926.59)
Container label from this SDS
For a container of Goo Gone Goo & Adhesive Remover you fill at work (29 CFR 1910.1200(f)(6)).
Goo Gone Goo & Adhesive Remover
Danger / Peligro
Exclamation Mark / Signo de exclamación
Health Hazard / Peligro para la salud
Hazard statements in English and Spanish
Code
English (as the sheet prints it)
Español (official European text)
H304
May be fatal if swallowed and enters airways.
Puede ser mortal en caso de ingestión y penetración en las vías respiratorias.
H317
May cause an allergic skin reaction.
Puede provocar una reacción alérgica en la piel.
The label carries 11 precautionary statements (P101, P102, P261, P280, P301, P310, P302, P352, P331, P333, P313, P362, P364, P405, P501), and the PDF prints their full text. 11 of its 13 lines have official Spanish; a line marked English only has none that says the same.
Finding the Goo Gone Goo & Adhesive Remover sheet is the easy part
Keeping every sheet read, current and ready for an inspector is the work that never ends. HazComFast does it with your crew: the AI extracts each sheet, and every reading leaves a proof.
Extraction: the AI reads every sheet
Scanned, long or in Spanish, it reads
Drop in the Goo Gone Goo & Adhesive Remover sheet, scanned or not, in English or Spanish. HazComFast reads every page, with progress shown page by page, so a 32-page sheet gets read to the last page.
Every section a foreman needs
Composition, spill response, storage, physical properties, stability and toxicology land on the product page with their source, so the sections a foreman actually needs aren't buried in a PDF.
The AI proposes, a person signs off
Each hazard shows where it came from: extracted from the sheet, or confirmed by a named person on a date. Confidence is measured against the text of the sheet, and below a floor every field is checked by hand before it saves.
A pictogram is never guessed
A pictogram only goes on your label if it's actually on the sheet or follows from its H-codes. H225 on the sheet means GHS02 and DANGER on the label, derived from OSHA's Appendix C.
Checked against 200 real sheets
Every change to the AI is checked against a reference set of 200 real SDSs before it ships. A field it isn't sure about is highlighted for you to check, and the inventory flags products whose extraction hasn't been validated yet.
Proof of reading, without the chasing
Nobody has to remember to ask
Add a hazardous product to a site and every worker there gets one notice with a 7-day due date. A reminder follows at day 3 and an escalation at day 7.
“I read it” can't be a reflex tap
The confirm button stays grey until the worker has scrolled through first aid or to the last page of the PDF and has spent 15 seconds there. The record keeps how long and how far.
A proof of reading the worker keeps
The worker ticks an attestation, and the record keeps which SDS version they read, the server time and the device. They can download their own PDF of it.
A new sheet means a new reading
When a manufacturer updates a sheet and the hazards change, everyone who confirmed the old one is asked to read the new one. Each confirmation keeps which version they read, for which jobsite.
Who read what, in one console
See who hasn't read what, nudge everyone overdue in one click, and export last month's confirmations for one jobsite, each with the SDS version they read.
The reading joins the training file
Each confirmed reading also lands in the worker's training file as a HazCom reading record, so your training records and your SDS records tell the same story.
From the sheet to the label
A label that can't go out empty
A label with five pictograms keeps all five, because the format switches. A label with no hazard information won't print. When the sheet changes, you get a relabeling task with its six-month deadline.
English and Spanish, side by side
Hazard and precautionary statements show in English and Spanish on every product page. A Spanish sheet that says PELIGRO is recorded as DANGER, and the original file stays attached as you received it.
Every print on record
Every print run is logged with exactly what went on the labels. When a hazard changes, the relabel task can only be closed by a print made after the change.
In the field, on the phone
Scan the drum
Scan the QR code on a drum and the page shows the maker and the CAS number under the title, so you know you hold the right one. A drum taken out of inventory still opens its SDS, marked as removed.
Search inside the sheet
Type “eye contact” and you land on first aid. Pinch to zoom on the small print.
Still there with no signal
Offline, the worker opens the sheet itself, with first aid and what to do in a spill. “Available offline” only shows when the PDF is on the phone.
When the inspector asks
The binder, in one click
One click gives you the jobsite's SDS binder, with Goo Gone Goo & Adhesive Remover in it, as a ZIP with a CSV index, and a dated CSV or PDF of who confirmed reading what. That is what you hand an inspector or a GC.
No expired-sheet myth
HazComFast never tells you a sheet has expired, because OSHA doesn't set an expiration date. You choose your own review interval, and the app labels it as your internal policy.
The chemical list behind it
Bring your spreadsheet
Imported products get the same pictograms as ones entered by hand, and importing the same file twice doesn't duplicate anything.
Each product, at every site
Each product page shows every site it's stored at with quantities, and warns you if something incompatible is stored at the same site.
A program that stays true
The chemical list in your HazCom program is built from each jobsite's inventory. Remove a product and the program tells you the list is out of date, with a button to rebuild it.
Start with the free SDS Binder Kit. It works with nothing but a printer.
Where do I get the SDS for Goo Gone Goo & Adhesive Remover?
From Goo Gone. The button at the top of this page opens its own copy (many product codes, SDS date Sep 19, 2024). It covers Goo Gone Goo & Adhesive Remover in the product numbers listed.
Is Goo Gone Goo & Adhesive Remover a hazardous chemical under OSHA?