The Clorox Company's sheet for Pine-Sol Original Multi-Surface Cleaner lists eye irritation, Category 2A, so it is a hazardous chemical as 29 CFR 1910.1200(c) defines it. The HazCom program, label, sheet and training paragraphs follow ((e)(1), (f)(6), (g)(8) and (h)(1)), unless a scope paragraph of (b) takes the product out.
Product as the sheet names it
CloroxPro® Pine-Sol® Multi-Surface Cleaner1, Original Pine
Maker
The Clorox Company
Document number
USA004000
Revision date as read on Oct 21, 2026
Dec 13, 2023 (the sheet calls it "Issue date")
CloroxPro Pine-Sol Multi-Surface Cleaner1, Original Pine, EPA registration number 5813-135-67619. This is the workplace sheet; the consumer product has its own label.
Read in the maker's sheet on October 21, 2026: Document number USA004000, Issue date Dec 13, 2023, 14 pages. The maker's version is the one that counts.
CloroxPro® Pine-Sol® Multi-Surface Cleaner1, Original Pine: facts read in the safety data sheet, by section
Signal word: Warning. Pictograms: Exclamation Mark (GHS07).
H319 Causes serious eye irritation
Section 3, ingredients
Alcohols, C10-14, ethoxylated (CAS 66455-15-0) at 5 to 10 %, citric acid (CAS 77-92-9) at 1 to 5 %, and sulfonic acids, C10-18 alkane, sodium salts (CAS 68037-49-0) at 1 to 5 %.
The sheet withholds the exact percentages as a trade secret.
Section 4, first aid
Eyes: rinse with water for several minutes, remove contact lenses if easy to do and keep rinsing. Get medical attention if irritation persists.
Skin: flush with cool water and wash with soap and water. Get medical attention if irritation persists.
Inhaled: if symptoms develop, move to fresh air. Get medical attention if they persist.
Swallowed: do not induce vomiting. If vomiting occurs, have the person lean forward to reduce the risk of aspiration. Get medical attention.
Section 5, fire fighting
Treat for the surrounding material, and do not use a water jet, which will spread the fire.
Gases hazardous to health may form in a fire, and the sheet notes no unusual fire or explosion hazards.
Firefighters wear self-contained breathing apparatus and full protective clothing, and move containers out of the fire area if that is safe.
Section 7, handling and storage
Keep containers tightly closed in a dry, cool, well-ventilated place.
Avoid contact with skin and eyes and do not breathe mist or vapor.
Keep out of reach of children.
Section 8, exposure limits
The sheet lists no OSHA permissible exposure limit for this product. Section 8 lists no occupational exposure limit and notes no biological exposure limit.
Section 8, protection
Respiratory protection: Where exposure guideline levels may be exceeded, use an approved NIOSH respirator, selected under OSHA's respirator standard (29 CFR 1910.134).
Chemical goggles.
Chemical-resistant gloves and clothing.
The sheet names eyewash equipment.
Section 9, flash point
> 199.4 °F (> 93.0 °C)
Section 9, other properties
Clear amber liquid with a pine odor.
pH 2.3. Relative density 0.998. Not explosive and not oxidizing.
Section 10, what to avoid
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources, and do not mix with other chemicals.
Incompatible with strong oxidizing agents.
Section 14, transport
Not regulated as dangerous goods by DOT.
What this product triggers under OSHA
The sheet gives an EPA registration number (5813-135-67619). A pesticide subject to FIFRA labeling is outside the HazCom labeling paragraphs, so no label is offered here; the sheet and training paragraphs still apply. (29 CFR 1910.1200(b)(5)(i))
The sheet says it is not applicable for consumer use, where the precautionary and first aid language is on the label. The standard does not apply to a consumer product the employer shows is used as its maker intended, at no more than consumer exposure. (29 CFR 1910.1200(b)(6)(ix), (b)(5)(v))
Section 8 mentions a respirator: the employer provides one when necessary to protect health and keeps a respiratory protection program. (29 CFR 1910.134(a)(2); 1926.103)
A classified product brings a written program with its chemical list, training, an accessible sheet and workplace labels. (29 CFR 1910.1200(c), (e)(1), (f)(6), (g)(8), (h)(1); 1926.59)
Container label from this SDS
No label is offered here: the product is an EPA-registered pesticide. To label a container of a product you do use, the secondary container label maker builds the label from the sheet you type in.
Finding the Pine-Sol Original Multi-Surface Cleaner sheet is the easy part
Keeping every sheet read, current and ready for an inspector is the work that never ends. HazComFast does it with your crew: the AI extracts each sheet, and every reading leaves a proof.
Extraction: the AI reads every sheet
Scanned, long or in Spanish, it reads
Drop in the Pine-Sol Original Multi-Surface Cleaner sheet, scanned or not, in English or Spanish. HazComFast reads every page, with progress shown page by page, so a 32-page sheet gets read to the last page.
Every section a foreman needs
Composition, spill response, storage, physical properties, stability and toxicology land on the product page with their source, so the sections a foreman actually needs aren't buried in a PDF.
The AI proposes, a person signs off
Each hazard shows where it came from: extracted from the sheet, or confirmed by a named person on a date. Confidence is measured against the text of the sheet, and below a floor every field is checked by hand before it saves.
A pictogram is never guessed
A pictogram only goes on your label if it's actually on the sheet or follows from its H-codes. H225 on the sheet means GHS02 and DANGER on the label, derived from OSHA's Appendix C.
Checked against 200 real sheets
Every change to the AI is checked against a reference set of 200 real SDSs before it ships. A field it isn't sure about is highlighted for you to check, and the inventory flags products whose extraction hasn't been validated yet.
Proof of reading, without the chasing
Nobody has to remember to ask
Add a hazardous product to a site and every worker there gets one notice with a 7-day due date. A reminder follows at day 3 and an escalation at day 7.
“I read it” can't be a reflex tap
The confirm button stays grey until the worker has scrolled through first aid or to the last page of the PDF and has spent 15 seconds there. The record keeps how long and how far.
A proof of reading the worker keeps
The worker ticks an attestation, and the record keeps which SDS version they read, the server time and the device. They can download their own PDF of it.
A new sheet means a new reading
When a manufacturer updates a sheet and the hazards change, everyone who confirmed the old one is asked to read the new one. Each confirmation keeps which version they read, for which jobsite.
Who read what, in one console
See who hasn't read what, nudge everyone overdue in one click, and export last month's confirmations for one jobsite, each with the SDS version they read.
The reading joins the training file
Each confirmed reading also lands in the worker's training file as a HazCom reading record, so your training records and your SDS records tell the same story.
From the sheet to the label
A label that can't go out empty
A label with five pictograms keeps all five, because the format switches. A label with no hazard information won't print. When the sheet changes, you get a relabeling task with its six-month deadline.
English and Spanish, side by side
Hazard and precautionary statements show in English and Spanish on every product page. A Spanish sheet that says PELIGRO is recorded as DANGER, and the original file stays attached as you received it.
Every print on record
Every print run is logged with exactly what went on the labels. When a hazard changes, the relabel task can only be closed by a print made after the change.
In the field, on the phone
Scan the drum
Scan the QR code on a drum and the page shows the maker and the CAS number under the title, so you know you hold the right one. A drum taken out of inventory still opens its SDS, marked as removed.
Search inside the sheet
Type “eye contact” and you land on first aid. Pinch to zoom on the small print.
Still there with no signal
Offline, the worker opens the sheet itself, with first aid and what to do in a spill. “Available offline” only shows when the PDF is on the phone.
When the inspector asks
The binder, in one click
One click gives you the jobsite's SDS binder, with Pine-Sol Original Multi-Surface Cleaner in it, as a ZIP with a CSV index, and a dated CSV or PDF of who confirmed reading what. That is what you hand an inspector or a GC.
No expired-sheet myth
HazComFast never tells you a sheet has expired, because OSHA doesn't set an expiration date. You choose your own review interval, and the app labels it as your internal policy.
The chemical list behind it
Bring your spreadsheet
Imported products get the same pictograms as ones entered by hand, and importing the same file twice doesn't duplicate anything.
Each product, at every site
Each product page shows every site it's stored at with quantities, and warns you if something incompatible is stored at the same site.
A program that stays true
The chemical list in your HazCom program is built from each jobsite's inventory. Remove a product and the program tells you the list is out of date, with a button to rebuild it.
Start with the free SDS Binder Kit. It works with nothing but a printer.
Questions about Pine-Sol Original Multi-Surface Cleaner
Where do I get the SDS for Pine-Sol Original Multi-Surface Cleaner?
From The Clorox Company. The button at the top of this page opens its own copy (Document number USA004000, Issue date Dec 13, 2023). It covers CloroxPro Pine-Sol Multi-Surface Cleaner1, Original Pine, EPA registration number 5813-135-67619. This is the workplace sheet; the consumer product has its own label.
Is Pine-Sol Original Multi-Surface Cleaner a hazardous chemical under OSHA?
Yes: Section 2 lists eye irritation, Category 2A (29 CFR 1910.1200(c)). Its consumer wording matters (1910.1200(b)(6)(ix)). As a pesticide, its label follows FIFRA (1910.1200(b)(5)(i)).